![]() If axle shaft and bearing show no signs of distress, they can be reinstalled along with a new axle shaft seal. Attach Tool C-637 to end of selected remover, using a slide hammer motion, remove axle shaft bearing and inspect and discard if axle shaft or bearing shows any of the conditions. (9) To remove the axle shaft bearing from axle housing (Fig. (8) Remove axle shaft seal from housing bore. The normal bearing contact on the shaft will be a dull gray and may appear lightly dented. If any of these conditions are present both the shaft and the bearing should be replaced. (7) Inspect the axle shaft bearing surfaces for signs of brinnelling, spalling or pitting. (6) Remove axle shaft from housing being careful not to damage the axle shaft bearing which will remain in the rear axle housing. (5) Push axle shaft toward center of vehicle and remove the āCā locks from recessed groove of axle shaft (Fig. (4) Turn differential case to make differential pinion shaft lock screw accessible and remove lock screw and pinion shaft (Fig. ![]() ![]() (3) Loosen housing cover and drain lubricant from rear axle and proceed to remove cover. Clean all dirt and foreign material from area of housing cover. (2) Remove wheel cover and wheel and tire assembly. Removal and Disassembly (1) vehicle to a desirable working height and install jack stands. diff cover and "c" clips need removal, to take out axles.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |